Enterasys SecureStack C2, Руководство по настройке, Страница: 151 / 607

set port jumbo
SecureStack C2 Configuration Guide 5-13
set port jumbo
Use this command to enable or disable jumbo frame support on one or more ports.
Syntax
set port jumbo { enable | disable }[ port-string]
Parameters
Defaults
If port ‐ string is not specified, jumbo frame support will be enabled or disabled on all ports.
Mode
Switch command, read ‐ write.
Example
This example shows how to enable jumbo frame support for Gigabit Ethernet port 14 in slot 3:
C2(su)->set port jumbo enable ge.3.14
clear port jumbo
Use this command to reset jumbo frame support status to enabled on one or more ports.
Syntax
clear port jumbo [ port-string]
Parameters
Defaults
If port ‐ string is not specified, jumbo frame support status will be reset on all ports.
Mode
Switch command, read ‐ write.
Example
This example shows how to reset jumbo frame support status for Gigabit Ethernet port 14 in slot 3:
C2(su)->clear port jumbo ge.3.14
enable | disable Enables or disables jumbo frame support.
port ‐ string (Optional) Specifies the port(s) on which to disable or enable jumbo
frame support. For a detailed description of possible port ‐ string values,
refer to “ Port String Syntax Used in the CLI ” on page 5 ‐ 2.
port ‐ string (Optional) Specifies the port(s) on which to reset jumbo frame
support status to enabled. For a detailed description of possible
port ‐ string values, refer to “ Port String Syntax Used in the CLI ” on
page 5 ‐ 2.