Enterasys SecureStack C2, Руководство по настройке, Страница: 148 / 607

set port speed
5-10 Port Configuration
Syntax
show port speed [ port-string]
Parameters
Defaults
If port ‐ string is not specified, default speed settings for all ports will display.
Mode
Switch command, read ‐ only.
Example
This example shows how to display the default speed setting for 1 ‐ Gigabit Ethernet port 14 in
slot 3:
C2(su)->show port speed ge.3.14
default speed is 10 on port ge.3.14.
set port speed
Use this command to set the default speed of one or more ports. This setting only takes effect on
ports that have auto ‐ negotiation disabled.
Syntax
set port speed port-string { 10 | 100 | 1000 }
Parameters
Defaults
None.
Mode
Switch command, read ‐ write.
Example
This example shows how to set
ge
.3.3 to a port speed of 10 Mbps:
C2(su)->set port speed ge.3.3 10
port ‐ string (Optional) Displays default speed setting(s) for specific port(s). For a
detailed description of possible port ‐ string values, refer to “ Port String
Syntax Used in the CLI ” on page 5 ‐ 2.
port ‐ string Specifies the port(s) for which to a speed value will be set. For a
detailed description of possible port ‐ string values, refer to “ Port
String Syntax Used in the CLI ” on page 5 ‐ 2.
10 | 100 | 1000 Specifies the port speed. Valid values are: 10 Mbps, 100 Mbps, or
1000 Mbps.