Enterasys SecureStack C2, Руководство по настройке, Страница: 131 / 607

set lldp port trap
SecureStack C2 Configuration Guide 4-25
Mode
Switch command, read ‐ write.
Example
This example enables both transmitting LLDPDUs and receiving and processing LLDPDUs from
remote systems on ports
ge
.1.1 through
ge
.1.6.
C2(rw)->set lldp port status both ge.1.1-6
set lldp port trap
Use this command to enable or disable sending LLDP notifications (traps) when a remote system
change is detected.
Syntax
set lldp port trap { enable | disable } port-string
Parameters
Defaults
None.
Mode
Switch command, read ‐ write.
Example
This example enables transmitting LLDP traps on ports
ge
.1.1 through
ge
.1.6.
C2(rw)->set lldp port trap enable ge.1.1-6
set lldp port med-trap
Use this command to enable or disable sending an LLDP ‐ MED notification when a change in the
topology has been sensed on the port (that is, a remote endpoint device has been attached or
removed from the port).
Syntax
set lldp port med-trap { enable | disable } port-string
Parameters
enable Enable transmitting LLDP traps on the specified ports.
disable Disable transmitting LLDP traps on the specified ports.
port ‐ string Specifies the port or range of ports to be affected.
enable Enables transmitting LLDP ‐ MED traps on the specified ports.
disable Disables transmitting LLDP ‐ MED traps on the specified ports.
port ‐ string Specifies the port or range of ports to be affected.