Enterasys ROAMABOUT RBT-1602, Руководство по установке, Страница: 18 / 56

Connection Options
1-4 Access Point Overview
Connection Options
You can connect an AP to switches through an intermediate Layer 2 or Layer 3 network. In either
case, use Category 5 (Cat 5) cable with straight ‐ through signaling for each AP connection.
You also can provide data link redundancy by connecting both of its ports to switches through the
network.
You can provide switch management redundancy even on a single AP Ethernet port by
connecting the AP to multiple switches through an intermediate Layer 2 or Layer 3 network.
Table 1-1 Access Point LEDs
LED Appearance Meaning
Health Solid green All the following are true:
• Management link with a switch is operational.
• AP has booted.
• AP has received a valid configuration from a switch.
• At least one radio is enabled or is in sentry mode.
Solid amber AP is waiting to receive boot instructions and a configuration
file from a switch.
Alternating green and
amber AP is booting and receiving its configuration file from a switch.
Radio 1
Radio 2 Solid green A client is associated with the radio.
Blinking green Associated client is sending or receiving traffic.
Blinking amber Non-associated client is sending or receiving traffic.
Alternating green and
amber Radio is unable to transmit. This state can occur due to any of
the following:
• Excessive radio interference in the environment is preventing
the radio from sending beacons.
• The radio has failed.
Unlit Means one of the following:
• Radio is disabled.
• Radio is enabled, but no clients are associated with the radio
and there is no traffic activity.
Note: Install the Cat 5 cables for the access point at the installation site before installing the access
point itself. During installation, you will insert the Cat 5 cable(s) into the access point port(s) before
attaching the access point to the bracket.