Enterasys 7100G Series, Руководство по установке оборудования, Страница: 45 / 90

Pin Out Descriptions Completing the Installation
Enterasys 7100G-Series Hardware Installation Guide 2-21
Completing the Installation
After installing the 7100G-Series switch and making the connections to the network, access the
device management startup screen from your PC or terminal connection as described in the
following section.
Start the Command Line Interface (CLI) from the device’s local console port as follows:
1. Connect a terminal to the local console port as described in “ Connecting to the COM Port for
Local Management ” on page 2-19. The startup screen displays.
2. At the login prompt, enter one of the following default user names:
– ro for Read-Only access
– rw for Read-Write access
– admin for Super User access. (This access level allows Read-Write access to all modifiable
parameters, including user accounts.)
3. Press Enter .
4. The Password prompt displays. Leave this string blank and press Enter . The device
information and 7100G-Series switch prompt appear as shown above.
The 7100G-Series switch is now ready to be configured. For information about setting the IP
address and configuring Telnet settings for remote access to 7100G-Series switch management,
refer to the
Enterasys 7100 Series Configuration Guide .
The CLI commands enable you to initially set up and perform more involved management
configurations. The
Enterasys 7100 Series Configuration Guide is available online at:
https://extranet.enterasys.com/downloads/Pages/default.aspx
Note: This procedure applies only to initial log-in and to logging in to a device not yet configured
with administratively-supplied user and password settings.
By default, the 7100G-Series switch is configured with three user login accounts: ro for Read-Only
access; rw for Read-Write access; and admin for super-user access to all modifiable parameters.
The default password is set to blank (null). For information on changing these default passwords,
refer to the
Enterasys 7100-Series Configuration Guide .
login: admin
Password:
7100G-Series
Command Line Interface
Enterasys Networks, Inc.
9 Northeastern Blvd.
Salem, NH 03079 U.S.A.
Phone: +1 603 952 5000
E-mail: support@enterasys.com
WWW: http://www.enterasys.com
(c) Copyright Enterasys Networks, Inc. 2012
Chassis Serial Number: xxxxxxxxxxxx
Chassis Firmware Revision: xx.xx.xx
7100(su)->