7-76
ENSTROM 480B OPERATOR'S MANUAL
Rev.
24
Report No. 28-AC-023
May 2/19
7-80. Power Sockets
1. The aircraft may be equipped with optional power
sockets. The power sockets provide a source of 28Vdc
and/or 14Vdc power for powering portable/removable
devices from the aircraft electrical system. The power
sockets, located on the top or sides of the center pedestal
assembly, are protected by either fuses or circuit breakers
(refer to the supplemental schematic diagrams provided
with the aircraft).
2. The power sockets are placarded with the voltage
type and maximum current load.
7-81. Headset Jacks
1. The aircraft is equipped with headset jacks for
each seat position. Insert the headset plug into the jack that
corresponds with the seat in the aircraft.
NOTE
The headset jack locations described below are
typical for a 4- or 5-place configuration.
a. The pilot and passenger #4 headset jacks (HDST
PLT and HDST PASS) are located on the upper left side of
the cabin backwall. The co-pilot headset jack (HDST CO-
PLT) is located on the right side of the cabin behind the co-
pilot seat near the floor. Passenger #1 (co-pilot seat
position) headset jack (HDST PASS) is located on the right
side of the lower console. Passenger #2 and passenger #3
headset jacks (HDST PASS) are located on the upper right
side of the cabin backwall.
NOTE
Noise-cancelling powered headsets must be
switched to ON.
2. Volume Adjustment. Refer to the specific model
headset, ICS/VOX or audio panel operation manual for
volume adjustment.
