ensto Chago Media, Инструкции по установке, Инструкции по эксплуатации

Страница: 29 / 49

RAK107
22.5.2018
29
8 Charging Point Maintenance / Preventive
Maintenance Instructions
1 x per year
WARNING! Danger of electrical shock or injury.
Disconnect power before working inside the device or
removing any components.
X MAINTENANCE ACTION
Retighten all screws (electric components).
Check the Mode 3 socket and if needed change it (burn or parts damage) (socket cost not
under warranty).
Check the charging cable and if needed change it.
Check the sealings.
Gently push the charging point with a hand to create vibration to ensure no bad contact /
connec- tion exist (wire or PCB).
Gently push the controller to create vibration to ensure no bad contact / connection exist
(wire or PCB).
Create fail and charge (with RFID card) to check all the LED states / color (green, blue, red) and
RFID reader is functioning.
Test available electricity at the sockets; use Mode 3 tester if needed. All the contacts (L1, L2, L3
must be tested).
With Mode 3 tester, test the functioning of Mode 3 (from green to blue).
Check tightness of the PE-cable screw.
Test voltage between PE and N (must be less than 10 V).
Test PE quality (must be less than 3
Ω).
SW update if needed (if in service contract).
Restart the station from F0, ensure it will restart properly.
Maintanance performed by: Date: