USER MANUAL
PTM 535 / PTM 535U / PTM 535J
–
ENOCEAN TRANSMITTER MODULE
© 2019 EnOcean | www.enocean.com
F-710-017, V1.0
PTM 535 / 535J User Manual | v1.5 | September 2020 | Page 32/36
6.3.2
ISED regulatory statement
6.3.2.1
English version
This radio transmitter has been approved by Industry Canada to operate with the antenna
types listed with the maximum permissible gain indicated. Antenna types not included in
this list, having a gain greater than the maximum gain indicated for that type, are strictly
prohibited for use with this device.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
1.
This device may not cause interference, and
2.
This device must accept any interference, including interference that may cause un-
desired operation of the device.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to ICES-003. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a par-
ticular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:
◼
Reorient or relocate the receiving antenna.
◼
Increase the separation between the equipment and receiver.
◼
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
◼
Consult the dealer or an experienced radio/TV technician for help
