EnOcean EDK 300, Начало работы

Страница: 7 / 23

V1.5 05/2011 Page 7/24
2.3 Example: ‘1-Channel Relay Switch’ (Mode 2)
1-channel relay mode to switch a light actuator. Telegrams from a learned PTM 2x0 push
button will change status of output ADIO7 (CH0).
1. Check jumper configuration of EVA 300 ac-
cording to the image on the right side, espe-
cially MODE2 jumper
2. Connect EVA 300 to delivered USB power
supply
3. Switch on EVA 300 board
4. Learn PTM 2x0 (switch) ID to TCM3x0:
- Press EVA 300 LEARN > 0.5s
(LMI LED will light, CH0 flash)
- Push PTM 2x0 to send learn telegram
- Wait until CH0 LED will flash
- Finish learn mode with LEARN button
> 0.5s
5. Switching PTM 2x0 will toggle CH0 LED (relay
pin)
Attention:

If you have changed TCM firmware: Load
EnOcean TCM 300 default firmware from CD
 If you have changed mode settings:
Clear ID
- press CLEAR button > 2s
(LEDs “LMI” will light & “CH0” blink)
- press RESET (mode selection)
TCM 300
USB power supply
CH0
LMI
optional / not equipped