Website: www.enlitelighting.com
Document version – EN-ST100_V1_18_ENG&FRE.DOC
GB
UK
Tel: +44 (0) 1727 83 66 11
Email: [email protected]
m
France
Tel: +33 (0) 1 30 11 11 88
Email: [email protected]
m
UAE
Tel: +971 (0) 4 328 5489
Email: [email protected]
Australia
Tel: +61 (0) 2 9882 6000
Email: [email protected]
South Africa
Tel: +27 (0) 11 234 4878
Email: [email protected]
m
EN-ST100 - SINGLE COLOUR LED STRIP LIGHT
PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLATION
LEAVE A COPY FOR THE USER / MAINTENANCE ENGINEER FOR FUTURE REFERENCE
IMPORTANT INSTALLATION INFORMATION
•
Installation should be carried out in accordance with the latest edition of the National Wiring Regulations. If in
doubt, consult a qualified electrician.
•
Keep the LED Driver away from direct sources of heat such as Low Voltage lamps.
•
Ensure that ALL electrical connections are tight with no loose strands, including factory connections.
•
Indoor use only.
•
Constant Voltage drivers and parallel connections must be used.
INSTALLATION INSTRUCTIONS
Before commencing installation or maintenance, ensure electricity is switched off at the mains.
1.
A 12V DC LED Driver must be used with this strip.
2.
Ensure that the surface that the LED strip will be applied to is clean and free from grease
3.
Peel of the backing tape and fix the LED strip into the required position using the self-adhesive backing.
4.
The LED strip may be cut to length with cut points every 50mm.
5.
A maximum of 10m can be connected in one length. Runs over 10m must be connected in parallel. See Diagram
1 for connection details.
6.
Connect the LED Strips to the 12V DC Constant Voltage LED Driver and ensure that the polarity is correct. Also
refer to the instructions provided with the LED Driver
7.
Connect the Constant Voltage LED Driver to the mains supply.
8.
The LED strip will now be lit.
Environmental Protection (W.E.E.E.) – Enlite’s WEEE Reg.No. WEE/BG0130YX (UK Only)
Waste Electrical & Electronic Equipment Regulations (WEEE) requires that any of our products showing this marking (left)
must not be disposed of with other household or commercial waste. Enlite does not levy any WEEE disposal charges to its
customers for affected WEEE related products. To prevent possible harm to the environment or human health from
uncontrolled waste disposal, please separate any such product from other waste types and recycle it responsibly at your
local facilities. Check with your Local Authority, Recycling Centre or retailer for recycling advice. If, when you purchased any
Enlite product, your supplier included a WEEE disposal fee, you should then contact your supplier for advice on his take
back of the product for the correct disposal.
GUARANTEE
These products are guaranteed for 3 years from the date of purchase. The guarantee is invalid in the case of improper use, installation,
tampering, removal of the Q.C. date label, installation in an improper working environment or installation not according to the current
edition of the National Wiring Regulations. Should this product fail during the guarantee period it will be replaced free of charge, subject to
correct installation and return of the faulty unit. Enlite does not accept responsibility for any installation costs associated with the
replacement of this product. These rights are in addition to your statutory rights in your country of purchase. Enlite reserves the right to
alter specifications without prior notice.
Diagram 1: Typical Installation with 50W Driver and 10m EN-ST100
240V ~ 50Hz
EN-ST100
EN-ST100
AU-LED5012CV
Constant Voltage
LED Driver
12V DC
12V DC
10m maximum
In one length
