The heater does not heat.
●
Check that the fuses to the heater are in good condition.
●
Check that the connection cable is connected.
●
Turn the timer switch to the “on” section.
●
Turn the thermostat to a higher setting.
●
Check that the overheat protector has not gone off. The timer works but the heater does not heat.
The sauna room heats slowly. The water thrown on the sauna stones cools down the stones
quickly.
●
Check that the fuses to the heater are in good condition.
●
Check that all heating elements glow when the heater is on.
●
Turn the thermostat to a higher setting.
●
Check that the heater output is sufficient.
●
Check the sauna stones. Too tightly piled stones, the settling of stones with time or wrong stone
type can hinder the air flow through the heater, which results in reduced heating efficiency.
●
Check that the sauna room ventilation has been arranged correctly.
The sauna room heats quickly, but the temperature of the stones remains insufficient. Water
thrown on the stones runs through.
●
Turn the thermostat to a lower setting.
●
Check that the heater output is not too high.
●
Check that the sauna room ventilation has been arranged correctly.
Panel or other material near the heater blackens quickly.
●
Check that the requirements for safety distances are fulfilled.
●
Check the sauna stones.
●
Too tightly piled stones, the settling of stones with time or wrong stone type can hinder the air
flow through the heater, which may result in overheating of surrounding materials.
The heater emits smell.
• See section Heating of the Sauna.
• The hot heater may emphasize odours mixed in the air that are not, however, caused by the sauna or
the heater. Examples: paint, glue, oil, seasoning.
• Occasional bangs are most likely caused by stones cracking due to heat.
• The thermal expansion of heater parts can cause noises when the heater warms up.
Control panel display is unusual:
●
If the control panel temperature display is over 189, make sure to connect the heat sensor securely.
●
If the control panel time display is -- (two dashes), the sauna is in continuous working mode. Press the
timer button to return to the timed working mode.
48
Содержание Diamond-3
Страница 28: ...Step 4 Place 2 full spectrum heaters on the front wall besides the door 31 ...
Страница 30: ...3 Timer Control reduce 7 Lights Button Pause 4 Timer Control increase 33 ...
Страница 38: ...OTHER ACCESSORIES Bucket with ladle Analog Thermostat Rocks Sand Timer Hourglass Clock Wall for Sauna 41 ...
