ENKHO 158382.01, Оригинальное руководство пользователя

Страница: 21 / 48

21
EN
The device cannot be used while it is being charged.
1. Connect the Micro USB plug of the charging cable (8) to the charging socket of the glue
gun (14), and connect the USB charging cable (9) to the charging socket (Micro USB
connection) of charger (7).
2. Insert the mains plug of the charger (13) into a socket. The Battery capacity indicator (3)
lights up .
Red: The device is being charged up,
Green: the charging process has completed and the glue gun is ready to use.
The recommended charging time is 3 hours.
NOTE: If the LED indicator light is red and flashing, means there is problem on the
battery. Stop charging and send it to Service Centre to get repaired.
3. After charging, first remove the mains plug of the charger (13) from the socket. Then
disconnect the Micro USB plug of the charging cable (8) from the glue gun.
Preparing the surfaces to be glued
Do not use flammable solvents to clean the surfaces to be glued.
The ambient temperature and the materials to be bonded may not be colder than 5°C
and not warmer than 50°C.
The area to be glued must be clean, dry and free of grease
◊ Smooth surfaces should be roughened before gluing.
◊ Quick-cooling materials such as steel should be warmed a little to facilitate adhesion.
Inserting a glue stick
Push the glue stick (4) into the feeder shaft (5).
Caution, danger of burns! Do not touch the hot glue or hot nozzle!
Switching on:
1. Press the on/off switch (2) until the temperature indicator (1) lights up red and the
battery capacity indicator (3) lights up green/red. The glue is heated up.
2. Allow the appliance to heat up for about 60 seconds.
3. The temperature indicator (1) lights up green as soon as the appliance has reached
working temperature 170ºC. The appliance is now ready to use.