© Enhanced Beverage Solutions | August 2019 | Revision 2.003 | Patent Pending
www.enhancedbeveragesolutions.com | @enhancedbeveragesolutions | #TapCulture
INSTALLATION INSTRUCTIONS
Continued...
-DUAL
Step 1: Preparation
If you are installing your Nitro Infuser in an existing system, the nitrogen gas must be shut off and the system depressurized,
including the kegs. Set the regulator to 0 psi. Open the tap faucet to release pressure.
Step 2: Identify Mounting Location for Nitro Infuser
The Nitro Infuser will be mounted within the kegerator, on the tap lines from the kegs to the tap faucets. Placement of your Nitro
Infuser on the inside wall of the kegerator near the top is ideal. For best performance, the Output lines to the faucet should be as
short as possible.
*Please note, infusing a beverage with nitrogen causes the liquid to freeze faster. To prevent freezing, install your infuser further
from the cooling mechanism (typically found near the back of the kegerator) and turn temperature up to approximately 33.5°F or
higher. Refer to your kegerator’s manual to ensure there is no electricity or cooling element behind selected location.
Thank you for purchasing a Nitro Infuser Dual!
Follow the instructions below to get started.
Installation videos and manuals may be found at:
www.enhancedbeveragesolutions.com/support
Beverage
Keg
Nitrogen
Gas
28 psi
Beverage
Keg B
Kegerator
Stout Faucet
Beverage
Keg A
T
To Faucet
To Faucet
T
Provided T Fitting
Provided T
Fitting
Gas B
Gas A
Beverage A
Beverage B
Output A
Output B
NCS
NCS
*Barbs on Nitro Infuser are permanently affixed and not designed to be removed.
REMOVAL OF BARBS VOIDS WARRANTY