AERATOR PUMP INSTRUCTIONS:
Pump arrives with the battery partially charged. Please
fully charge overnight before 1st use. The pump will
switch on when it is plugged into the USB charger, this
is normal operation. Simply press the power button to
turn it off, and it will continue to charge.
CHARGING INSTRUCTIONS:
Open the rubber seal over the USB plug on the pump
and rotate it 90 degrees. Plug in USB-C adapter on
the right side of the pump and leave charging until all
lights stop flashing. A full charge usually takes about
4 hours. A maximum full charge will keep the pump
running for up to 36 hours, depending on conditions
and temperature. Do not leave this USB port open and
exposed to the elements. Always fully close the USB
port seal before using outdoors.
3rd party USB battery packs may be used to run the
pump for longer periods.
USAGE INSTRUCTIONS:
Power
– Press once to turn on and a
second time to turn off.
Intermittent
– Press once for a 10 second
on and 10 second off cycle. Press again to
disengage.
Air Flow
-Turn pump on first. Press the
+/- once to cycle through speeds. There are 4 LEDs
above the icons to indicate speeds. The LED’s from left to
right indicate increasing pump speed. The corresponding
LED will flash for a second when you press the +/-.
SAFETY HAZARD WARNINGS FOR LITHIUM-ION
POLYMER BATTERIES
You must read these safety warnings and
instructions before using or charging your Engel
Aerator Pump.
Rechargeable Lithium-ion polymer batteries
are potentially hazardous and can present a
serious FIRE HAZARD, SERIOUS INJURY and/
or PROPERTY DAMAGE if damaged, defective or
improperly used.
By purchasing the Engel Aerator Pump with
Lithion-Ion battery, you assume all risks
