ENFORCER
Piezoelectric Mullion-Style Outdoor Stand-Alone Keypads
SECO-LARM U.S.A., Inc 11
SECO-LARM U.S.A., Inc.
33 11
1.
Enter a user ID number ( to ). The LED will turn green.
2.
If the LED is red, previous user data exists. Clear it by entering . The keypad will beep in
confirmation and the LED will turn green.
3.
Swipe a new user card. The keypad will sound 1 short and 1 long beep and the LED will remain green.
4.
Return to Programming Mode by pressing .
NOTE: Must return to Programming Mode after learning a card, otherwise user will overwrite existing card.
5.
To program the next user, repeat from step 1 in section A, B, or C.
6.
Exit Programming Mode by pressing again.
1.
Enter a user ID number ( to ). The LED will turn green.
2.
If the LED is red, previous user data exists. Clear it by entering . The keypad will beep in
confirmation and the LED will turn green.
3.
Enter a new user code. The keypad will sound 2 short beeps and the LED will turn yellow.
4.
To program the next user, repeat from step 1 in section A, B, or C.
5.
Exit Programming Mode by pressing .
1.
Enter Programming Mode by entering the Master Code twice. The LED will turn yellow.
2.
Enter . The LED will flash yellow.
3.
Enter one of the following:
User card ONLY
Either user card OR user code (DEFAULT)
User card AND user code
The keypad will sound 2 short beeps and the LED will turn yellow.
NOTE: Deleting all users is recommended before changing the access mode to user card AND user code.
See pg. 14, Deleting All Users.
4.
Exit Programming Mode by pressing .
1.
Enter Programming Mode by entering the Master Code twice. The LED will turn yellow.
(Default Master Code is 1234)
2.
Enter . The LED will flash green.
3.
If the LED is solid green, a Master Card is already programmed. Clear it by entering .
The keypad will sound 2 short beeps in confirmation and the LED will start flashing green.
4.
Swipe a proximity card (PR-K1S1A or similar). The keypad will sound 2 short beeps and the LED will
turn yellow. This card is now the Master Card.
5.
Exit Programming Mode by pressing .
Programming Output #1:
E.
Setting the Output #1 Access Mode*
DEFAULT: User card OR user code.
0
0 0
0 1
0 2
Each Output #1 user can be programmed to have a user code, a user card, or both a user code and card.*
A.
Programming User Codes
NOTE: For all of the following programming functions, the keypad must be in Programming Mode. To enter
Programming Mode, enter the Master Code twice or swipe the Master Card.
*SK-2323-SPAQ only.
D.
Program the Master Card (SK-2323-SPAQ only)
In addition to a Master Code, a Master Card can also be programmed. Swiping a Master Card will give
direct access to Programming Mode.
7
B.
Programming User Cards*
#
#
#
#
#
0 0 0
9 9 9
0 0 0
9 9 9
