2
SUBMERSIBLE PUMP
USER’S MANUAL
EWP-SUB-103GPH
Figure 4
Step 1:
Insert the 14 AWG cable stripped end through the clamp cap (39),
rubber seal (38) and screw cap (37).
Step 2:
Connect the stripped ends to the cable connector
(no specific polarity) and tighten using an Allen key.
Step 3:
Plug the connector into the pump in the proper orientation (D shape), place the rubber
gasket (not shown) around the connector, and tighten the screw cap to the pump.
Step 4:
Insert the rubber seal inside the clamp fingers on the screw cap, ensuring it is fully
inserted, and then fully tighten the clamp cap.
Figure 5
Figure 6
Figure 7
3. CABLE WIRING INSTALLATION
