EnerSys Alpha FXM HP 1100, Техническое руководство

Страница: 99 / 150

0170022-J0 Rev A Page 87
9.3.13 Configure Keep Alive
The Keep Alive function provides a method of restoring communication when a communication failure
is detected. A reset temporarily removes power and resets the local communication equipment powered
by this unit.
To configure the Keep Alive function:
1. Go to
System > FXM System > System Functions > Keep Alive
.
2. From the Status table, enable Keep Alive Enable .
3. From the Configuration table, configure the
Destination IP Address
.
4. If there is an active Keep Alive failure alarm, click on the Reset Keep Alive Failure button to clear
the failure.
9.3.14 Configure Soft Shutdown
T he Soft Shutdown function allows a third party software that is compatible with MegaTec protocol
to monitor the status the FXM HP and shutdown the system during AC failure.
To configure the Soft Shutdown function:
1. Go to Controller > Advanced Function > Soft Shutdown.
2. In the Configuration table, set the Soft Shutdown System value.
3. Verify the Soft Shutdown State is Ready.
4. Connect a serial cable from the USB-Mini B connector to the computer running the third party soft
-
ware.
9.3.15 Configure SNMP UPS Management Information Base
The SNMP UPS Management Information Base (MIB) allows a 3rd party software to monitor the status
the FXM HP and shutdown the system during AC failure over the SNMP network.
To configure UPS MIB System function:
1. Go to Controller > Configure Controller > Communication > SNMP
2. Set the
SNMP Agent
to Enabled.
3. In the Configuration table, set the UPS MIB System value.
9.3.16 Configure Relays
Contacts C1 to C5 allows the FXM HP to be connected to an external monitoring panel or traffic control
equipment. For contact C6, the default factory configuration is +48 or +24 Vdc output.
The FXM HP unit has a list of predefined conditions that can energized a relay.
• On Battery – the battery is providing backup power to the load