Enerpac EFBE5017, Инструкция

Страница: 8 / 24

8
8.0 MAJOR FEATURES AND COMPONENTS
8.1 Trigger On-Off Switch
NOTICE:
WARNING To prevent serious personal injury, be
certain that hands, fingers and other body parts are
away from the cutting area before depressing the
cutter trigger.
A trigger mounted in the cutter grip controls cutter
operation. Pressing the trigger automatically starts the
cutter electric motor.
• Press and hold the trigger to advance the piston and
slide the moving blade forward. See Figures 2 and 3.
• Release the trigger at any time to stop the piston and
moving blade. Be advised that there may be a brief
delay until the piston comes to a complete stop.
• After the piston is fully advanced the piston will
automatically reverse direction and move to the fully
retracted “home” position. See Figure 4.
• Automatic return can occur only after the piston has
been fully advanced. If the trigger is released before
the piston is fully advanced, the piston will stop and
remain stopped.
Figure 2, Trigger On-Off Switch
Figure 3, Piston and Blade Fully Advanced
6.0 SET-UP
6.1 Delivery and Handling
The cutter and various related items are housed inside a
plastic storage case. The cutter should be stored in this
case when not in use.
Place the cutter on a substantial and stable work
surface. The work surface must be of sufficient capacity
to support the weight of the cutter plus the additional
weight of the material to be cut. Refer to Section 2.2 for
cutter weight.
6.2 Before Startup
• Be sure that the shipment includes all components
and that there is no obvious damage.
• Read the following sections of this manual to become
familiar with cutter features and safety devices.
• Verify that the AC power supply is of the correct
specifications and capacity to power the cutter. Refer
to Section 7.0 of this manual for additional information.
NOTICE Be sure that cutter piston is advanced as far
as possible before removing oil reservoir cap in the
next step. Oil leakage and improper operation may
result if this instruction is not followed.
• Advance the piston as far as possible, disconnect AC
power cord and check the cutter hydraulic oil level.
Add oil if oil level is low. Refer to Section 10.5.2 for
detailed instructions.
• Be sure that the piston release lever is fully tightened.
Refer to Section 8.2.
• Before first use, remove air from the cutter hydraulic
system. Refer to procedure in Section 9.3.
7.0 POWER REQUIREMENTS
The cutter is available in two versions, each with different
electrical power requirements:
Model EFBE5017B is designed for 120VAC, single-
phase, 60 Hz power. This version contains a USA style
NEMA 6-15 power plug.
Model EFBE5017E is designed for 230VAC, single-
phase 50 Hz power. This version contains a European
style “Schuko” power plug.
Before connecting electric power to tool, be certain that
the power supply is the proper voltage and Hz for the
cutter version that you are using. Refer to the cutter data
plate.
Also refer to Sections 1.3 and 1.4 of this manual for
important electrical safety information and precautions.
NOTICE:
WARNING Failure to follow the electrical safety
precautions contained in Sections 1.3 and 1.4 of this
manual could result in electric shock. Death or
serious personal injury could occur.