Enerpac EDCH130, Инструкция

Страница: 8 / 16

8
Figure 1, Features and Components
1
2
3
5
4
Key:
1. Shear Blades
2. Positioning Handle #1
3. Control Knob (open/close) 4. Hydraulic Hoses
5. Positioning Handle #2
3.0 CONFORMANCE TO NATIONAL AND
INTERNATIONAL STANDARDS
Enerpac declares that this product has been
tested and conforms to applicable standards
and is compatible with all CE requirements.
A copy of an EU Declaration of Conformity is
enclosed with each shipment of this product.
4.0 DESCRIPTION
Enerpac models EDCH130, EDCH145 and EDCH170
are fixed-head shear blade decommissioning cutters.
Hydraulic power is supplied by an Enerpac hydraulic
pump, which is sold separately from the cutter. Refer to
Section 6.1 for additional pump information.
See Figure 1 for a description of cutter major features
and typical items included in the shipment. Refer to
Section 2.0 for cutter maximum capacities, specifications
and dimensions.
5.0 RECEIVING INSTRUCTIONS
Visually inspect all components for shipping damage.
Shipping damage is not covered by warranty. If shipping
damage is found, notify carrier at once. The carrier is
responsible for all repair and replacement costs resulting
from damage in shipment.
6.0 SET-UP
6.1 Hydraulic Pump Requirements
The cutter must be used in conjunction with a specially
designed hydraulic pump (sold separately). This pump
contains unique valving and controls that are specific to
the cutter.
Refer to the pump instruction sheet for detailed
pump setup and operation instructions. Also refer to
Section 6.3 of this manual for additional details.
6.2 Hydraulic Connections
A high pressure twin hydraulic hose assembly connects
the pump control valve to the cutter. This hose assembly
is not included with the cutter and must be purchased
separately. A chafe gear covering is also available as a
separate accessory to help provide additional protection
for the hoses.
To facilitate connections, quick-disconnect hydraulic
couplers are present on the hoses, the cutter, and on the
pump control valve.
NOTICE:
WARNING
Hydraulic oil can reach very high
temperatures even when the cutter is idle and cutting
force is not being applied. To prevent burns, always
use suitable personal protective equipment when
connecting or disconnecting couplers on a cutter
that has been in operation.