Energy GPV3.6KTL, Руководство пользователя

Страница: 55 / 65

49
10 Troubleshooting
When the PV system does not operate normally, we recommend the following
solutions for quick troubleshooting. If an error occurs, the red LED will light up. There
will have “Event Messages" display in the monitor tools. The corresponding corrective
measures are as follows:
Object Error
code Corrective measures
6
• Check the open-circuit voltages of the strings and make
sure it is below the maximum DC input voltage of the
inverter.
• If the input voltage is within the permitted range and
the fault still occurs, it might be that the internal circuit
has broken. Contact the service.
33 • Check the grid frequency and observe how often major
/ Stick Hand-tight
Socket
wrench
Open end of 33 Swivel nut of M25 cable gland Hand-tight
Open end of 15 Swivel nut of sunclix connector 2.0Nm
Wire stripper Peel cable jackets
/
Crimping tools Crimp power cables
/
Hammer drill,
drill bit of Ø10
Drill holes on the wall
/
Rubber mallet Hammer wall plugs into holes
/
Cable cutter Cut power cables
/
Multimeter Check electrical connection
/
Marker Mark the positions of drill holes
/
ESD glove
Wear ESD glove when opening the
inverter
/
Safety goggle
Wear safety goggle during drilling
holes.
/
Anti-dust respirator
Wear anti-dust respirator during
drilling holes.
/