Energie FF Evi 10, Инструкция по установке и эксплуатации

Страница: 29 / 59

ENERGIE Page | 27
17.5 View probes values
To check the probes value must perform the following procedures:
a) Go to the
controller “µC²SE” and;
b) Press " " or " " keys and you have access to the probes values.
Probe Description
B1
Water temperature (Inlet)
B2 Water temperature (Outlet)
B3 Evaporator temperature
B4
Suction pressure in heating mode (absolute value).
Compression pressure in cooling mode.
17.6 Access levels/ Programming
The parameters divide into 4 different levels according to their accessibility
by the user via password and their function.
“Factory”:
it allows the configuration of all unit parameters;
“Super User”:
accessible with password (11), it allows the
configuration of the Super User, User and Direct parameters;
“User”:
accessible with password (22), it allows the configuration of
those parameters that can be set typically by the user and Direct,
therefore relative to the options.
“Direct”: accessible by pressing “ ” for 5 s, it allows to read the
probes and any data, which can be interrogated by anyone without
compromising unit operation.
17.7 Parameters modification procedure
a.
Press “ “ and “ ” for 5 s;
b. The and
symbols appear along with “00”;
c. Set the password via
“ ” or “ ” and confirm with “ “;
d. Select the parameters menu (S-
P) via “ ” or “ “. Confirm with “
”;
e. Select the parameters category (A,b,c,d..) via
“ ” or “ “.
Confirm with “ ”;
f.
Select the parameter via “ ” or “ “. Confirm with “ ”;
g.
Modify the parameter value with “ ” or “
;