ECO
Installation Instructions and Use & Care Guide
9
Transporting the equipment must be carried out with an inclination below 45º;
The equipment must be raised and lowered with extreme care to avoid impact that could damage
the material;
Make sure the belts and/or transportation straps do not damage the material;
Always use means of transportation suitable for the equipment (pallet lift, forklift, etc…);
The equipment must be transported in its original package to the place of installation. Check, before
beginning transport, if the path you will travel is unobstructed, in order to prevent collisions that could cause
damage to the device.
3.
PACKAGE
The equipment is supplied in three packages, one for the thermodynamic panel and its attachment
elements, one for the storage water heater and another for the thermodynamic group together with the
hood and elements to attach to the storage water heater.
4.
INSTALLATION INSTRUCTIONS
4.1.
DETERMINING WATER HEATER LOCATION
The location chosen for the water heater must take the following into consideration:
LOCAL INSTALLATION REGULATIONS
This water heater must be installed in accordance with these instructions, local codes, utility codes,
and utility company requirements or, in the absence of local codes, the latest edition of the National
Electrical Code.
POWER REQUIREMENTS
Check the markings on the rating plate of the water heater to verify the power supply corresponds
to the water heater requirements (240V/15A).
LOCATION
Locate the water heater indoors, in a clean, dry area as near as practical to the area of greatest
heated water demand. Long uninsulated water lines can waste heat, energy and money.
The water heater and water lines should be protected from freezing temperatures and highly
corrosive atmospheres. Do not install the water heater in outdoor or unprotected areas.
The water heater should not be located in an area where leakage of the tank or connections will result in
damage to the area adjacent to it or to lower floors of the structure. Where such areas cannot be avoided,
it is recommended that a suitable, adequately drained catch pan be installed under the water heater.
