EndRun Sonoma N12, Руководство пользователя

Страница: 98 / 174

S o n o m a U s e r M a n u a l 82
C H A P T E R N I N E
83 S o n o m a U s e r M a n u a l
C O N T R O L A N D S T A T U S C O M M A N D S
TAU is the system oscillator control loop averaging time constant, in seconds. It’s
value is automatically adjusted to maintain optimum offset and stability.
EFCDAC is the system oscillator Electronic Frequency Control 20-bit DAC value. The
system automatically sets this value to remove frequency errors. Values may
range from 0 to 1048575. Values close to the maximum or minimum will set the
DAC fault flag that will appear in the fault status display. The Time/Status
display will also indicate a fault condition.
TEMP is the chassis internal temperature in °C.
Below is an example of a typical response to this command:
Command:
oscctrlstat
Sonoma reply:
20170117.00:23:10 LKD 0 6.26e-09 -6.26000e-09 1.25e-09 -6.93e-13 1955.3
524281 +50.750
passwd
This command is used to change the password for the user that you are logged in as. It affects the
serial port, SSH, Telnet and HTTP.
passwd
is a Linux command that is also described in Appendix
C - Helpful Linux Information
.
Command:
passwd
Sonoma reply: Interactive script is started.
ptpconfig0 and ptpconfig1 (Optional)
These commands are only available if the Precision Time Protocol (PTP) option has been installed.
Refer to
Chapter 4 - PTP/IEEE-1588
for more information.
ptpstat0 and ptpstat1 (Optional)
These commands are only available if the Precision Time Protocol (PTP) option has been installed.
Refer to Chapter 4 - PTP/IEEE-1588 for more information.
pwrfltmask (Optional)
See Chapter 10 - Options, Masking Dual Power Supply Fault Alarms for information on this com-
mand.
rcvrserialnumber
This command is not available in units shipped before June 2017.
It shows the serial number of the
EndRun GPS Receiver inside Sonoma. See Chapter 1 - Introduction, GPS Receivers for informa-
tion on EndRun’s GPS Receiver.