EndRun Sonoma N12, Руководство пользователя

Страница: 78 / 174

S o n o m a U s e r M a n u a l 62
C H A P T E R S E V E N
63 S o n o m a U s e r M a n u a l
H T T P S I N T E R F A C E
Coast Duration This shows the number of seconds the GPS Subsystem has been in coast mode,
while the Sonoma is unlocked to GPS. Coast mode is another term for holdover
mode.
Estimated Time This is the estimated time error of the GPS Subsystem when in coast/holdover
Error mode, in seconds.
Internal Chassis Internal chassis temperature in °C. Available with OCXO or Rubidium
Temperature oscillator.
Clock Page
This page shows the configuration of the Sonoma Time Server except for any optional I/O which is
listed on the I/O page.
Clock Configuration
Time Mode This field shows the current time mode setting. Possible settings are UTC, GPS
and Local. Since NTP always uses UTC, this setting only affects any optional
Time Code or Serial Time outputs. To change the time mode setting
use the
systimemodeconfig
command via the console port.
Time Zone This field shows the offset from UTC and is only valid when the Time Mode is
Offset Local. A positive Time Zone Offset implies a longitude east of the Greenwich
meridian. To change the time zone use the
systimemodeconfig
command.
Daylight Savings This field will show whether DST control is enabled or not.
Time DST fields are only used when the Time Mode is Local.
DST Start, These fields will only display if the Daylight Savings Time field above shows
DST End enabled. If enabled, then these fields show when DST starts and ends during the
year. For example, in most of the U.S.A. the DST Start Time is the 2nd Sunday
in March at 2 a.m. The DST End Time is the 1st Sunday in November at 2
a.m. DST settings are used when the time mode is Local. To change the DST
settings use the
systimemodeconfig
command.
I/O Page
This page shows any installed CPU Options and their settings. These are optional outputs that are
generated from the CPU Module in the Sonoma. A basic Sonoma Time Server has no CPU Options
installed. Use commands
cpuioconfig
and
sysioconfig
via the console port to change the set-
tings of the CPU Options. See Chapter 10 - Options for information on the various options.
Faults: System Faults Page
This page lists all possible fault conditions of the Sonoma. For details on each fault see Appendix G
- System Faults
.