Endress ESE 3000 i, Перевод инструкции по эксплуатации, Страница: 33 / 63

33
Commissioning
A hand start 1. Turn the tank ventilation valve Fig. 6-2 to the position “ON“ on the tank
cover.
2. Open the fuel valve by turning the rotary knob into the “I“ position.
3. Pull the choke lever fully for a cold engine, somewhat less for a hot en-
gine.
4. Move the engine start switch into the “I“ position.
5. Support yourself with one hand or a foot on the device and pull strongly on
the grab handle of the cable pull starter/
The engine starts.
6. Do not just release the grab handle but instead lead it carefully back into
the generator.
The green operation indicator light lights up.
7. Push the choke lever back in again slowly. If the engine begins to run un-
evenly, pull out the choke lever out a little for a short time and repeat the
process.
The motor runs at a stable speed.
You can connect to one piece of power consuming equipment.
You can use ECO mode (see Chapter 8.2 .
NOTICE!
Do not apply load to the generator immediately after a cold start.
► Allow the generator engine to warm up for a few minutes before switching on
a load when the generator has not been operating for more than eight hours
(or for very low external temperatures).
7.4 Turning off your power generator
Proceed as follows to switch off your generator:
Requirements

the attached power consuming equipment is disconnected or switched off.
CAUTION!
Certain surfaces on the device can get very hot whilst it is running.
Risk of burns
► Never touch any engine parts (in particular the exhaust system) for a few min-
utes after ceasing operation.
► Always leave hot engine parts to cool down before touching them.
Switching the gen-
erator off 1. Continue to run the engine without load for about two minutes.
2. Move the engine start switch Fig. 7-3 - into position “0“.
The engine comes to a standstill and the generator is switched off.
3. Turn the rotary knob on the fuel valve Fig. 7-3 - back into position “0“.
The generator is switched off and secured.