Endress ECO Power Line ESE 3000 BS, Перевод оригинального руководства по эксплуатации

Страница: 37 / 60

37
Commissioning
3. Move the choke lever into the "CLOSE" position
4. Switch the generator switch into the "ON" position
5. Pull the cable pull starter out until you feel some resistance and then pull
it out vigorously.
The engine starts.
6. Move the choke lever slowly back into the "OPEN" position after the en-
gine has warmed up.
The engine has started.
NOTICE!
Do not apply load to the generator immediately after a cold start.
► Allow the generator engine to warm up for a few minutes before switching on
a load when the generator has not been operating for more than eight hours
(or for very low external temperatures).
NOTICE!
The automatic low-oil system will not let the engine start if the oil level is
too low.
► First refill up to the engine oil level (see Chapter 8.3.1 ), before you restart
the engine.
► The automatic low-oil system cannot stop the engine from being damaged
due to a low oil level in all cases. Never start the engine without checking the
oil level beforehand!
7.6 Turning off your power generator
Proceed as follows to switch off your generator:
Requirements:  All of the connected consumers must be disconnected or switched off
CAUTION!
Certain surfaces on the device can get very hot whilst it is running.
Risk of burns
► Never touch any engine parts (in particular the exhaust system) for a few min-
utes after ceasing operation.
► Always leave hot engine parts to cool down before touching them.
Switching the gen-
erator off 1. Continue to run the engine without load for about two minutes.
2. Switch the generator switch into the "OFF" position
3. Turn the fuel valve into the "OFF" position
4. Allow the device to cool down.
The generator is switched off and secured.