Endress+Hauser WirelessHART Fieldgate SWG70, Руководство по эксплуатации

Страница: 29 / 138

WirelessHART Fieldgate SWG70 Operation
E Hauser 29
6.1.1 LEDs
Five LEDs indicate the status of Fieldgate SWG70.
Fig. 6-2: LED indicators
Yellow LED: RS-485
communication status
Green LED: Power supply
and operation status
Yellow LED: WirelessHART
communication status
Red LED: Device status
1 Yellow LED: RS-485 communication status
2 Green LED: Power supply
3 Yellow LED: WirelessHART communication status 4 Red LED: Device status
5 Yellow LED: Ethernet communication status
+24V +24V 0V 0V
LINE1 LINE2
A B SHD
RS485
T1
T2 RX– RX+ TX– TX+
ON
OFF
SHD
A
B SHD
RS485
ETHERNET
1
2 3 4 5
Mode Status Meaning
Flashes – Flashes briefly whenever a valid message is received by the
Fieldgate on the RS-485 communication line.
– The LED does not flash if the message is not addressed to the
Fieldgate or if a communication error was detected within the
message.
Off – Currently no communication on the RS-485 line.
Mode Status Meaning
On OK Fieldgate SWG70 is powered up and running
Flashes Not ready On power-up, indicates that the Fieldgate application is running
but the Fieldgate is not yet ready to answer HART commands.
Off No power The power supply is not connected/Fieldgate is not ready.
Mode Status Meaning
Flashes – Flashes shortly whenever a valid WirelessHART message is
received by the Fieldgate on the WirelessHART communication
interface.
– Messages include simple commands but not published bursts
and event notifications.
Off – Currently no communication on the WirelessHART interface.
Mode Status Meaning
On Hardware fault Fieldgate has detected a hardware fault that makes normal
operation impossible.
Flashes Recovering from hardware
fault. The Fieldgate application is trying to recover from the fault (not
possible for all faults).
Off No hardware fault –