Endress+Hauser Topclean S CPC30, Руководство по эксплуатации

Страница: 70 / 178

6 Commissioning Topclean S
70 Hauser
Operating mode Redox
To enter the menu, proceed as follows:
⇒ ⇒
CHOICE
(default = bold) INFO
Offset
Manual calibration
Cal. settings
Calibration timer
Calibration menu selection
Offset : Entry of a fixed value by which the mV value is displaced.
Manual calibration : Initial settings for the function of the CAL
key.
Cal. settings : General calibration settings
Calibration timer : Clock for calibration
Offset:
Act. PV 1/2:
Offset 1/2 0650 mV
0000 mV Enter Offset value for redox value
Act. PV : current measured value (primary value)
Offset : redox value difference in mV
When you enter the measuring mode while an offset is active,
"OFFSET" will be shown on the right top of the display.
Manual calibration:
For redox abs.
Enter data abs.
Calibration abs.
Calibration parameter
Sets the calibration type undertaken when the "CAL" key is
pressed:
Enter data abs . : Enter the electrode offset in mV.
Calibration abs. : The electrode offset is calculated from the
difference between the current measured value and the known
buffer value.
For: Redox %:
Enter data abs.
Enter data rel.
Calibration abs.
Calibration rel.
Enter data abs . : Enter the electrode offset in mV.
Enter data rel. : Entry of two % calibration points to which mV
values are assigned.
Calibration abs. : The electrode offset is calculated from the
difference between the current measured value and the known
buffer value.
Calibration rel. : Use of a non-toxic sample and an unchanged
sample as buffer.
Cal. settings:
0120 mV
(1 ... 1500 mV)
Entry of offset deviation of the mV value for the alarm
function
If the offset deviates from the reference offset by the value entered
here, an alarm can be triggered.
PARAM
pH
7.00
Param Parametrieren
Grundeinstellung
Sonderfunktionen
Handbedienung
Quick
Setup
Edit Weiter E
pH
7.00
Hold
Param Settings
Set up 1
Set up 2
Manual operation
First start up
Edit Next E
pH
7.00
Param
Edit Next
Set up 1
E
Hold
Relays
Temperature
Alarm
Hold
Calibration
Hold 650 mV
Param
[E]
Offset
Act. PV 1
Offset 1:
Next Select
0650 mV
0000 mV
[¯®]
Hold 650 mV
[E]
Cal. buffer
Enter data abs.
Calibration abs.
Next Edit[¯]
Param
Hold 650 mV
[E]
Cal. buffer
Enter data abs.
Calibration abs.
Next Edit[¯]
Param
Enter data rel.
Calibration rel.
Hold 650 mV
[E]
Zeropoint 1
120 mV
Next Edit[¯ ®]
Param
1... 1500mV