Endress+Hauser Teqwave F, Руководство по эксплуатации

Страница: 34 / 80

Commissioning Teqwave F/I Modbus TCP
34 Hauser
10 Commissioning
NOTICE
Damage to the touch surface
Sharp objects, electrostatic discharge, water and the use of pens not designed for touch
screens, such as standard pencils, can cause a malfunction of touch-control transmitters or
damage the touch surface.
‣
Do not use sharp objects to operate the touch screen.
‣
Make sure the touch surface does not come into contact with other devices.
‣
Make sure the touch surface does not come into contact with water.
‣
Only use your finger or a specially designed stylus pen to operate the touch surface.
10.1 Function check
Before commissioning the measuring device:
‣
Make sure that the post-installation and post-connection checks have been performed.
• "Post-installation check" checklist→  18
• "Post-connection check" checklist →  23
10.2 Switching on the measuring device
After a successful function check, switch on the measuring device.
After a successful startup, the local display switches automatically from the initial display
to the measured value display.
If nothing appears on the local display or an error message is displayed, refer to the
"Diagnostics and troubleshooting" section
10.3 Setting the operating language
In the case of transmitters with a touch screen, the operating language is configured via
the local display.
The language is selected for the Viewer via "Teqwave Viewer" → "Language settings".
The same range of options are available.
Navigation using transmitter with touch screen
Settings menu → "Language settings"
Once the user has selected the language, the operating tool communicates the
language setting to the transmitter.
Parameter Procedure Selection/input Factory setting
Language settings Tap to select the
language. • German
• English
• French
• Spanish
• Italian English
10.4 Configuring the measuring device
If you are using the transmitter with a touch screen, it is possible to configure the device
either via the transmitter touch screen or via the "Teqwave Viewer" operating tool. If you
are using the transmitter with LED status indication, the configuration must be performed
via the Viewer.