Endress+Hauser SWA70, Руководство по эксплуатации

Страница: 52 / 116

6 Operation WirelessHART Adapter SWA70
52 Hauser
6.2.2 Light emitting diodes
The light emitting diodes indicate the level of power that is available for the field device, for
instance. The level of the power supply changes after the power supply has been switched on or
returns.
6.3 Operating the field device
Operate your field devices as specified in the operating manual for the devices in question.
6.4 Local configuration and remote configuration
The WirelessHART Adapter is configured externally. There are various ways of doing this:
• Local configuration with FieldCare via modem and DTM for SWA70
• Remote configuration with FieldCare via WirelessHART Fieldgate SWG70 and DTM for SWA70
and SWG70
• Remote configuration with a software application and a gateway that are based on the device
description (DD).
FieldCare FieldCare uses the adapter DTM. With the adapter DTM it is possible to configure all the
parameters, such as the burst mode and event notification, via a wireless or wired connection.
Furthermore, comprehensive diagnostic information based on HART, NAMUR and ASM is available
for the WirelessHART Adapter, such as the remaining battery life, the join status of the
WirelessHART Adapter and the connected HART field devices. For more information see the
"Configuration" section on Page
59.
DD-based software DD-based software enables the remote configuration, monitoring and diagnosis of the
WirelessHART Adapter. The software accesses the WirelessHART Adapter via a DD-based gateway
and a wireless network. The functions that can be executed using the DD correspond to those of
the DTM. For more information see the "Configuration" section on Page
59. Please refer to the
gateway operating manual for more information.
LED 1
(green) LED 2
(yellow) LED 3
(green) Meaning
Ready Charge Power
ON OFF ON Normal operating mode
OFF OFF OFF No external power supply.
ON ON OFF Buffer has been partially charged.
ON ON ON 70% of the buffer has been charged. LED 3 switches off as soon as
the buffer is fully charged (100 %).