Endress+Hauser Solitrend MMP42, Краткое руководство по эксплуатации

Страница: 5 / 28

Solitrend MMP42 Basic safety instructions
Hauser 5
1.2 Documentation
The following documentation types are available in the Downloads section of the Endress
+Hauser website ( www.endress.com/downloads ):
For an overview of the scope of the associated Technical Documentation, refer to the
following:
• W@M Device Viewer ( www.endress.com/deviceviewer ): Enter the serial number from
nameplate
• Hauser Operations App : Enter the serial number from the nameplate or scan
the 2D matrix code (QR code) on the nameplate
2 Basic safety instructions
2.1 Requirements for personnel
The personnel for installation, commissioning, diagnostics and maintenance must fulfill the
following requirements:
‣
Trained, qualified specialists must have a relevant qualification for this specific function
and task.
‣
Personnel must be authorized by the plant owner/operator.
‣
Be familiar with federal/national regulations.
‣
Before starting work: personnel must read and understand the instructions in the manual
and supplementary documentation as well as the certificates (depending on the
application).
‣
Personnel must follow instructions and comply with general policies.
The operating personnel must fulfill the following requirements:
‣
Personnel are instructed and authorized according to the requirements of the task by the
facility's owner-operator.
‣
Personnel follow the instructions in this manual.
2.2 Designated use
Application and media
The measuring device described in this manual is intended for the continuous moisture
measurement of a wide variety of materials. Because of its operating frequency of approx.
1 GHz, the device can also be used outside of closed metal vessels.
If operated outside of closed vessels, the device must be mounted in accordance with the
instructions in the "Installation" section. The operation of the devices does not present any
health risk. If the limit values specified in the "Technical data" and the conditions listed in the
manual and additional documentation are observed, the measuring device may be used for the
following measurements only:
• Measured process variables: material moisture, material conductivity and material
temperature