Endress+Hauser Smart System SSP200B, Руководство по эксплуатации

Страница: 18 / 36

Electrical connection Smart System for Aquacultures SSP200B
18 Hauser
6.3 Cable entries and terminals
H 5 6 7 8 I
G F
E
D
C
A
1 2 3 4 B
A0018025
 12 Underside of housing with labeled cable entries and terminals
Labeling on underside of housing Description for Liquiline CM444 Description for Modbus Device
Edge
1 to 8 Sensors 1 to 8 Do not use
A Supply voltage Do not use
B RS485 In or M12 DP/RS485 (not
used in factory configuration) Do not use
C Freely usable LTE antenna
D Current outputs and inputs, relays
(not used in factory configuration) LTE antenna
E Do not use Do not use
F Current outputs and inputs, relays
(not used in factory configuration) Ethernet
G Current outputs and inputs, relays
(not used in factory configuration) Supply voltage
H Freely usable Do not use
I RS485 Out and M12 Ethernet
(M12 Ethernet used in factory
configuration) Do not use
6.4 Electrical connection Liquiline CM444
NOTICE
The transmitter does not have a power switch!
‣
Provide a protected circuit breaker in the vicinity of the transmitter at the place of
installation.
‣
The circuit breaker must be a switch or power switch, and must be labeled as the circuit
breaker for the device.