Endress+Hauser prosonic flow 92, Руководство по эксплуатации

Страница: 38 / 98

5 Operation Prosonic Flow 92
38 EHauser
5.3 Brief operating instructions for the function
matrix
!
Note!
• See the general notes on Page 39.
• Descriptions of device functions
→
see Page 63
1. Power on
→
start-up approx. 10 sec.
→
entering function matrix, group
MEASUREMENT
2. Select a group (e.g. SITE SETUP)
3. Select a function group (e.g. SITE DATA)
4. Select a function (e.g. PIPE MATERIAL)
Change parameter / enter numerical values:
Select or enter parameters, numerical values using cursor control,
U
,
V
,
W
,
W
, ENT
and ESC.
5. Exit the function matrix:
Power off
Fig. 31: Selecting functions and configuring parameters (function matrix)
1 Entering the function matrix
2 Selecting a group
3 Selecting a function group
4 Selecting a function level (1...3 sub-levels are possible depending on the function group)
!
Note!
To go from one group to the next, you must first activate the group navigator. To do so,
use the
U
key and then use the
V
and
W
keys to move up or down.
F
0
6
-9
2
x
xxxxx
-1
3
-xx-xx
-xx-0
0
0