Endress+Hauser Proline Promass E 100, Руководство по эксплуатации

Страница: 99 / 108

Proline Promass E 100 Modbus RS485 Technical data
Hauser 99
Sanitary compatibility • 3-A approval
• Only measuring devices with the order code for "Additional approval", option LP "3A"
have 3-A approval.
• The 3-A approval refers to the measuring device.
• When installing the measuring device, ensure that no liquid can accumulate on the
outside of the measuring device.
Remote transmitters must be installed in accordance with the 3-A Standard.
• Accessories (e.g. heating jacket, weather protection cover, wall holder unit) must be
installed in accordance with the 3-A Standard.
Each accessory can be cleaned. Disassembly may be necessary under certain
circumstances.
• EHEDG-tested
Only devices with the order code for "Additional approval", option LT "EHEDG" have been
tested and meet the requirements of the EHEDG.
To meet the requirements for EHEDG certification, the device must be used with process
connections in accordance with the EHEDG position paper entitled "Easy Cleanable Pipe
Couplings and Process Connections" ( www.ehedg.org ).
Pharmaceutical
compatibility
• FDA 21 CFR 177
• USP <87>
• USP <88> Class VI 121 °C
• TSE/BSE Certificate of Suitability
• cGMP
Devices with order code for "Test, certificate", option JG "Compliance with requirements
derived from cGMP, declaration" are in accordance with cGMP requirements relating
to the surfaces of wetted parts, design, FDA 21 CFR material conformity, USP Class VI
tests and TSE/BSE-compliance.
A manufacturer's declaration specific to the serial number is supplied with the device.
Modbus RS485 certification The measuring device meets all the requirements of the MODBUS/TCP conformity test and
has the "MODBUS/TCP Conformance Test Policy, Version 2.0". The measuring device has
successfully passed all the test procedures carried out.
Pressure Equipment
Directive
• With the identification PED/G1/x (x = category) on the sensor nameplate,
Hauser confirms conformity with the "Essential Safety Requirements" specified
in Appendix I of the Pressure Equipment Directive 2014/68/EU.
• Devices not bearing this marking (PED) are designed and manufactured according to
good engineering practice. They meet the requirements of Article 4 paragraph 3 of the
Pressure Equipment Directive 2014/68/EU. The range of application is indicated in
tables 6 to 9 in Annex II of the Pressure Equipment Directive 2014/68/EU.
Other standards and
guidelines
• EN 60529
Degrees of protection provided by enclosures (IP code)
• IEC/EN 60068-2-6
Environmental influences: Test procedure - Test Fc: vibrate (sinusoidal).
• IEC/EN 60068-2-31
Environmental influences: Test procedure - Test Ec: shocks due to rough handling,
primarily for devices.
• EN 61010-1
Safety requirements for electrical equipment for measurement, control and laboratory
use - general requirements
• IEC/EN 61326
Emission in accordance with Class A requirements. Electromagnetic compatibility (EMC
requirements).