Endress+Hauser Proline Promag H 100 EtherNet/IP, Краткое руководство по эксплуатации

Страница: 37 / 52

Proline Promag H 100 Electrical connection
Hauser 37
5. Insert dummy plugs into unused cable entries.
7.5 Post-connection check
Are cables or the device undamaged (visual inspection)? 
Do the cables comply with the requirements (→  24)? 
Do the cables have adequate strain relief? 
Are all the cable glands installed, firmly tightened and leak-tight? Cable run with "water trap"
(→  36) ?

Depending on the device version: are all the device plugs firmly tightened (→  28)? 
• Does the supply voltage match the specifications on the transmitter nameplate ?
• For device version with Modbus RS485 intrinsically safe: does the supply voltage match the
specifications on the nameplate of the Safety Barrier Promass 100 ?

Is the terminal assignment or the pin assignment of the device plug (→  26) correct? 
• If supply voltage is present, is the power LED on the electronics module of the transmitter lit green
(→  8)?
• For device version with Modbus RS485 intrinsically safe, if supply voltage is present, is the power LED
on the Safety Barrier Promass 100 lit (→  8)?

Is the potential equalization established correctly (→  29)? 
Depending on the device version, is the securing clamp or fixing screw firmly tightened? 