Endress+Hauser Proline Promag 51, Руководство по эксплуатации

Страница: 85 / 124

Proline Promag 51 9 Trouble-shooting
Hauser 85
9.2 System error messages
Serious system errors are always recognised by the instrument as “Fault message”, and are shown
as a lightning symbol (
$
) on the display. Fault messages immediately affect the inputs and outputs.
Simulations and positive zero return(not available with custody transfer mode), on the other hand,
are classed and displayed as notice messages.
No. Error message / Type Cause Remedy / spare part
S = System error
$
= Fault message (with an effect on the outputs)
! = Notice message (without an effect on the outputs)
!
Note!
• In custody transfer mode, “notice messages” of Promag 51 are always classified and treated as “fault messages”.
• Error response of the outputs
→
Page 92
No. # 0xx
→
Hardware error
001 S: CRITICAL FAILURE
$
: # 001
Serious device error Replace the amplifier board.
Spare parts
→
Page 94
Custody transfer mode:
To eliminate fault, lead seal must be
broken!
011 S: AMP HW EEPROM
$
: # 011
Amplifier:
Defective EEPROM Replace the amplifier board.
Spare parts
→
Page 94
Custody transfer mode:
To eliminate fault, lead seal must be
broken!
012 S:
$
AMP SW EEPROM
$
: # 012
Amplifier:
Error accessing EEPROM data Without custody transfer mode:
The EEPROM data blocks in which
an error has occurred are displayed in
the “TROUBLESHOOTING” func-
tion.
Press Enter to acknowledge the
errors in question; default values are
automatically inserted instead of the
errored parameter values.
Custody transfer mode:
To eliminate fault, lead seal must be
broken!
!
Note!
The measuring device must be
restarted after fault elimination.
031 S: SENSOR HW DAT
$
: # 031
Sensor DAT:
1.
S-DAT is defective.
2. S-DAT is not plugged into the
amplifier board or is missing.
1. Replace the S-DAT.
Spare parts
→
Page 94
Check the spare part set number
to ensure that the new, replace-
ment DAT is compatible with the
measuring electronics.
2. Plug the S-DAT into the amplifier
board
→
Page 96, 98
Custody transfer mode:
To eliminate fault, lead seal must be
broken!