Endress+Hauser Memosens CLL47E, Руководство по эксплуатации

Страница: 9 / 16

Memosens CLL47E Repair
Hauser 9
After cleaning, rinse the sensor thoroughly with water.
6.2 Sensor calibration
‣
Wall distance:
When calibrating, ensure that there is a minimum distance of 15 mm to the base and walls
of the calibration vessel.
7 Repair
7.1 General information
The repair and conversion concept provides for the following:
• The product has a modular design
• Only use original spare parts from the manufacturer
• Repairs are carried out by the manufacturer's Service Department or by trained users
• Observe applicable standards, national regulations and certificates
7.2 Return
The product must be returned if repairs or a factory calibration are required, or if the wrong
product was ordered or delivered. As an ISO-certified company and also due to legal
regulations, Hauser is obliged to follow certain procedures when handling any
returned products that have been in contact with medium.
To ensure the swift, safe and professional return of the device:
‣
Refer to the website www.endress.com/support/return-material for information on the
procedure and conditions for returning devices.
7.3 Disposal
If required by the Directive 2012/19/EU on waste electrical and electronic equipment
(WEEE), the product is marked with the depicted symbol in order to minimize the disposal
of WEEE as unsorted municipal waste. Do not dispose of products bearing this marking as
unsorted municipal waste. Instead, return them to Hauser for disposal under the
applicable conditions.