Endress+Hauser Liquiphant FTL62, Руководство по эксплуатации

Страница: 11 / 60

Liquiphant FTL62 HART Incoming acceptance and product identification
Hauser 11
4.2 Product identification
The following options are available for identification of the device:
• Nameplate data
• Extended order code with breakdown of the device features on the delivery note
• Enter serial number from nameplates in W@M Device Viewer
www.endress.com/deviceviewer . All of the information on the measuring device is
displayed along with an overview of the scope of technical documentation provided.
• Enter the serial number on the nameplate into the Hauser Operations app or
scan the 2-D matrix code on the nameplate with the Hauser Operations app
4.2.1 Nameplate
The information that is required by law and is relevant to the device is shown on the
nameplate, e.g.:
• Manufacturer identification
• Order number, extended order code, serial number
• Technical data, degree of protection
• Firmware version, hardware version
• Approval-related information, reference to Safety Instructions (XA)
• DataMatrix code (information about the device)
4.2.2 Manufacturer address
Hauser SE+Co. KG
Hauptstraße 1
79689 Maulburg, Germany
Place of manufacture: See nameplate.
4.3 Storage and transport
4.3.1 Storage conditions
Use original packaging.
Storage temperature
–40 to +80 °C (–40 to +176 °F)
Optional –50 °C (–58 °F) or –60 °C (–76 °F)
With M12 plug, elbowed: –25 to +80 °C (–13 to +176 °F)
4.3.2 Transporting the device
NOTICE
Flange, pipe extension and tuning fork are either plastic-coated or enamel-coated.
Scratches or impacts may cause damage to the coated surface of the device.
‣
Hold the device only by the housing, flange or extension pipe, protect coated surface
appropriately.
‣
Transport the device to the measuring point in the original packaging.
Do not bend, shorten or extend the tuning fork