Endress+Hauser Liquiline CA80SI, Руководство по эксплуатации

Страница: 50 / 172

Commissioning Liquiline System CA80SI
50 Hauser
L
WARNING
Connection errors
The safety of people and of the measuring point is under threat. The manufacturer does
not accept any responsibility for errors that result from failure to comply with the
instructions in this manual.
‣
Put the device into operation only if you can answer yes to all the following questions.
Device condition and specifications
‣
Are the hoses free from damage on the outside?
Visual inspection of the liquid-bearing lines
‣
Have the bottles with reagents, and standard been inserted and connected?
‣
Is the magnetic stir bar lying flat in the measuring chamber?
9.3 Switching on the measuring device
1. Connect the power supply.
2. Wait for the initialization to finish.
9.4 Setting the operating language
Configuring the language
1. Press the soft key: MENU .
2. Set your language in the top menu item.
 The device can now be operated in your chosen language.
9.5 Configuring the measuring device
9.5.1 Basic setup analyzer
Making basic settings
1. Switch to the menu Setup / Basic setup analyzer .
 Make the following settings.
• Device tag
Give your device any name of your choice (max. 32 characters).
• Set date
Correct the set date if necessary.
• Set time
Correct the set time if necessary.
2. Insert the bottles and activate the bottles used in the menu: Bottle insertion / Bottle
selection .
3. Check the concentration of the calibration standard used: Calibration / Settings /
Nominal concentration .
4. Optionally, also change the measuring interval: Measurement / Measuring interval .
 All the other settings can be left in the default factory settings for the time being.
5. Return to the measuring mode: press and hold the soft key for ESC for at least one
second.
 Your analyzer now works with your general settings. Optionally connected
sensors use the factory settings of the specific sensor type and the individual
calibration settings that were last saved.