Endress+Hauser Ecograph T RSG30, Руководство по эксплуатации

Страница: 51 / 86

Commissioning
51
Submenu: Ethernet Set up required if you are using the Ethernet interface of the unit.
!
Note!
Several user cannot access at the same time via provided PC software and Ethernet to the unit.
Fig. 37: Set up, Communication, Ethernet
MAC-Address MAC address (Fixed settings - cannot be changed). The MAC address (Media Access
Control) is the hardware address, which identificates the unit in the network.
IP Please input the IP-address (given by your network administrator). This IP address is
assigned by your network administrator. Please talk to your network administrator
about this.
The unit is delivered with a preset IP address which must, however, be changed in the
set up procedure. Before you can make the input in the unit, an IP address valid for your
network must be defined.
!
Note!
The IP address must be unique within the network!
Please be aware that this number is not arbitrary, rather it must be defined dependent
on the network address of the TCP/IP network. The input form corresponds to syntax
(e.g. 192.168.100.002).
Port Please check that settings are compatible with the PC settings! Fixed settings - cannot
be changed. Port preset at the factory to
"8000" .
!
Note!
The port "8000" must be opened on the Firewall of the accessing PC, with Web server
function open the port "80" too. Call your system administrator!
Subnetmask Please input the subnetmask (given by your network administrator).
The subnetmask must be input if the unit is to establish connections in another sub-
network. Specify the subnetmask of the sub-network in which the unit is located (e.g.
255.255.255.000). Please note: the IP address determines the network class. The result
of this is a default subnetmask (e.g. 255.255.000.000 for a Class B network).
Gateway Please input the Gateway (given by your network administrator).
Enter the IP address of the gateway here, if connections are to be established in other
networks.
Factory setting: 000.000.000.000
!
Note!
Changes to the system parameters are not activated until the set up menu is closed and
the settings accepted. Only then will the unit work with the new settings.
"Communication"
menu items
Configurable parameters
(Factory settings bold marked)