Endress+Hauser CLS15D, Руководство по эксплуатации

Страница: 21 / 32

Condumax CLS15D/16D/21D Commissioning
Hauser 21
Device condition and specifications Action
Are all cable entries mounted, tightened and leak-tight? In the case of lateral cable entries:
‣
Point cable loops downward so that water can
drip off.
Are all cable entries installed downwards or mounted laterally?
6 Commissioning
Prior to initial commissioning, ensure that:
• The sensor is correctly installed
• The electrical connection is correct
If using an assembly with automatic cleaning function:
‣
Check that the cleaning medium (water or air, for example) is connected correctly.
L
WARNING
Escaping process medium
Risk of injury from high pressure, high temperatures or chemical hazards!
‣
Before applying pressure to an assembly with cleaning system, ensure that the system has
been connected correctly.
‣
If you cannot reliably establish the correct connection, do not install the assembly in the
process.
Following commissioning, the sensor must be serviced at regular intervals, as only then
can reliable measurement be guaranteed.
Operating Instructions for the transmitter used, such as BA01245C if using the Liquiline
CM44x or CM44xR.
7 Maintenance
L
CAUTION
Corrosive chemicals
Risk of chemical burns to the eyes and skin and risk of damage to clothing and equipment!
‣
It is absolutely essential to protect the eyes and hands properly when working with acids,
alkalis and organic solvents!
‣
Wear protective goggles and safety gloves.
‣
Clean away splashes on clothes and other objects to prevent any damage.
‣
Comply with instructions in the safety data sheets for the chemicals used.