Installation and commissioning
SPECORD PLUS
20
}
Switch on the PC and install the ASpect UV program (see "ASpect UV software for
SPECORD PLUS" operating manual).
}
Connect the USB port of the SPECORD PLUS and the PC with the supplied USB cable.
Switch on the SPECORD PLUS and start ASpect UV.
When the SPECORD PLUS is connected for the first time, a device detection proce-
dure is performed and the AJ driver is assigned after the device is switched on.
}
After initialization of the SPECORD PLUS and activation of the lamps, wait for a run-
in time of 2 hours and then adjust the device with the aid of the software (→ "Check-
ing and correcting the adjustment"
ü
The SPECORD PLUS is now ready for operation.
5.3
Removing and fastening the transport locks
NOTICE
Before commissioning the SPECORD PLUS, remove or disable all transport locks!
The SPECORD PLUS has been fitted with transport locking screws on the monochroma-
tor and with foam blocks in the sample chamber for transport to prevent damage to the
device and its optics. The locking screw of the monochromator is located on the right
rear device side on the base plate. The SPECORD 250 PLUS has a second locking screw
to protect the upstream monochromator on the left rear device side. The Allen key for
removing the locking screw is inserted in one of the foam blocks in the sample chamber.
Removing the transport locks
}
Remove the white foam blocks between the sample chamber rods and take the Allen
key out of the block.
Figure 13Foam blocks protecting the support rods
}
Turn the transport locking screw on the left rear side counterclockwise (to "free" on
the sticker) with the Allen key until it stops.
}
SPECORD 250 PLUS only
Turn the second transport locking screw protecting the upstream monochromator on
the right rear side counterclockwise with the Allen key until it stops.
