Installation
qTOWER³ / qTOWER³ G
20
Figure 9 Voltage selection switch on the bottom of the device
}
Open the lid of the device. To do so, press in the red handle on the front until the
lock clicks open. Fold back the upper part of the device.
}
Remove the transport lock and put it aside for later transports.
}
Connect the connection cable to the device interface and to the PC.
}
Connect the power cable to the device. Plug the plug into the mains socket.
NOTICE! Ensure that the power switch and the power cable can be easily accessed.
This is important in the event that the device needs to be disconnected from the sup-
ply voltage.
}
Switch on the PC. Install the software on the PC. Observe the information in the soft-
ware manual for this.
}
Switch on the device via the power switch.
When first switched on, the device is detected as a connected device. After the driv-
ers install automatically, the device is ready for operation. If the drivers are not in-
stalled automatically, you can complete the installation via the Windows routine.
The drivers can be found on the installation CD or USB stick.
}
Start the software.
NOTICE! The device is only supported by software version 3.2 and higher.
}
If color modules have been installed, specify these in the software.
ü
The device is operational.
Operation is controlled via the software program. The settings for the measuring or
temperature program can be found in the software manual.