multi EA 4000
Maintenance and care
125
7.4.4
Cleaning the condensate container
Clean the condensate container as required:
1.
Detach the 2 knurled head screws (arrow) at the cover of the cooling
block and remove the cover.
2.
Pull the hoses off the connections of the condensate container.
3.
Inspect the condensate container for deposits and cracks.
4.
If necessary, rinse the condensate container with ultrapure water.
5.
Attach the hoses (see figure).
Hose no. 73 (from the bottom end of the condensation coil at the
rear) to the side inlet of the condensate container
Hose no. 77 (to the condensate pump) at the bottom outlet
Hose no. 74 (to the drying container) at the top outlet
Push the hoses approx. 1 cm onto the glass connections of the con-
densate container.
7.5
Manual TIC solids module
Maintenance task
Maintenance interval
Remove splashes of chemicals from the hous-
ing
Immediately
Clean the TIC reactor (Erlenmeyer flask)
After each sample
Changing the desiccant in the drying tube
As required (blackening or clumping due to
moisture absorption)
Replace the halide trap
when half of the copper wool or the brass
wool is discolored
Replace the water traps
As required, but no later than after 3
months
The desiccant in the drying tube is replaced in the same manner as in the basic device
multi EA 4000 (
→
see section "Changing the desiccant in the drying tube" p. 112).
The copper and brass wool in the halide trap is also replaced analogous to the replace-
ment of the halide trap in the basic device multi EA 4000 (
→
see section "Replace the
Maintenance intervals
Содержание Analytik Jena multi EA 4000
