73692-Porto3lt-Spot 20170619
Endon Lighting, LS9 0SE
Porto 3lt Spot Bathroom Light Fitting
Safety Warnings
INSTRUCTION MANUAL
•
This product is only suitable for connection to a 240V~50Hz supply in accordance with current IEE wiring
regulations. It should be installed in accordance with local building regulations and is for domestic ceiling use only.
• Before installing your light fitting always switch off the mains supply and remove the appropriate fuse or switch off
the appropriate circuit breaker before commencing installation.
•
This is a Class I product, and
must
be Earthed.
The terminal blocks are supplied according to requirements of the
fitting.
• Never fit bulbs of a higher wattage than those specified on the label (as these may cause overheating and
damage the fitting).
• This product contains delicate parts – be careful during handling and maintenance to avoid breakage.
•
This product has special protection against the ingress of water, and is rated IP44. If the glass or diffuser is broken
or cracked it must be replaced, please consult your retailer. This is the symbol which denotes this requirement:
•
This light may be installed in Zones 1 and 2 and Outside Zones of a bathroom where water jets are not used
for cleaning purposes. If installing in a bathroom, a 30mA RCD must be used in accordance with IEE Wiring
Regulations and the Building Regulations. An electrician must be
consulted if in any doubt about your own competency or meaning
of bathroom “Zones”, “Equipotential Bonding” or “RCD”.
•
If you are in any doubt about your competence please consult a
qualified electrician.
• If any modification is made it will invalidate the warranty and may
render the product unsafe.
•
Allow 10 minutes to cool before replacing, adjusting or cleaning.
• Clean with a dry cloth only. Do not use liquid or abrasive cleaners
on this product.
Assembly/ User Instructions
Before you start
Please read these instructions carefully before fitting and retain for reference. Check the packaging and make sure
that you have all the required parts. Follow each assembly step in order to prevent incorrect assembly. Ensure that
the product is fully assembled as illustrated before use.
This light fitting is suitable for use with a dimmer switch, but may not be dimmed if using certain energy saving
lightbulbs - please check lightbulb packaging.
The Light pack contains:
Light fitting.
Terminal connection block(s).
Fixing pack.
The following tools may be required:
Selection of cross and flat head screwdrivers.
Electric drill and assorted drill bits.
Wire strippers.
Electrical insulation tape.
OUTSIDE ZONES
ZONE
2
ZONE
1
0.6m
0.6m
2.25m
Ceiling
These assembly diagrams are intended as a guide – if in doubt consult a qualified electrician.
1.
Decide on the position of the light fitting, or remove existing light fitting. Take a note of the position of the electrical
connections. Ensure there is a solid mounting surface, preferably a wooden joist or joist bridge to support the weight
of the light fitting.
2.
Remove the two side screws (4) and retain for re-use. Use the fixing bracket (1) as a template to mark the screw
holes. Make the screw holes and secure to the ceiling with appropriate screw fixings (2).
