Hal Wall Light Fitting
Safety Warnings
INSTRUCTION MANUAL
• This product is only suitable for connection to a 240V~50Hz supply in accordance with current IEE wiring
regulations, and should be installed in accordance with local Building Regulations. They are for domestic, indoor
ceiling use only, and are
not
suitable for a Bathroom location.
• The light fitting should be connected to a lighting circuit protected by a 5 amp fuse (or a 6 amp miniature circuit
breaker).
• Before installing your light fitting always switch off the mains supply, and remove the appropriate fuse or switch
off the appropriate circuit breaker before commencing installation. Ensure that no one else has access that
would enable the supply to be inadvertently reconnected.
•
This is a Class 1 product and must be Earthed.
The terminal blocks are supplied according to requirements
of the fitting.
• Never fit bulbs of a higher wattage than those specified on the label (as these may cause overheating and
damage the fitting).
• If you are in any doubt about your competence please consult a qualified electrician.
• If any modification is made it will invalidate the warranty and may render the product unsafe.
76338
-Hal-WB 20180622
Endon Lighting, LS9 0SE
Assembly/ User Instructions
Please read these instructions carefully before fitting and retain for reference.
Check the packaging and make sure that you have all the required parts.
Follow each assembly step in order to prevent incorrect assembly.
Ensure that the product is fully assembled as illustrated before use.
The Light pack contains:
Light fitting.
Terminal connection block.
Fixing pack.
The following tools may be required:
Selection of cross and flat head screwdrivers.
Electric drill and assorted drill bits.
Wire strippers.
Electrical insulation tape.
Allen Keys
Personal protection equipment
These assembly diagrams overleaf are intended as a guide – if in doubt consult a qualified
electrician.
Before you start
Care Information
Allow 10 minutes to cool before replacing, adjusting or cleaning.
Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.
1. Decide on the position of the light fitting, or remove existing light fitting. Take a note of the position of the
electrical connections. Ensure there is a solid mounting surface.
2. Remove the two side screws (A) and retain them for re-use. Use the fixing bracket (B) as a template to
mark the screw holes, and secure to the wall with appropriate screw fixings (C), making sure the bracket is
correctly aligned.
3. Support your fitting and connect the house wiring to the terminal block (D) – see expanded wiring details
below. Any loose terminal blocks – not secured to ceiling cup – should always be covered with at least 2
layers of good quality insulation tape such that it is covered to at least 8mm on each side.
4. Secure the wall cup over the bracket by using the screws (A) removed in Point 2.
