1
Assembly/ User Instructions
INSTRUCTION MANUAL
Please read these instructions carefully before fitting your new light and retain for reference.
•
Outdoor Use:
•
It is recommended that this light be installed by a qualified electrician in accordance with current IEE
Wiring Regulations and Building Regulations ( Part P ).
•
Ensure that the mains electrical supply is isolated before commencing any installation.
•
Run supply wire from a 5-amp electrical supply using double insulated 2 or 3-core cable of type H05RN-F
1.0mm2 (not supplied) to selected site, ensuring it is adequately protected through the full length of the
cable run, it must come out of the flat surface of the wall in line with the entry to the fitting.
•
Except where installed in a conduit or duct which provides equivalent protection against mechanical
damage, a cable buried in the ground shall incorporate an earthed armour or metal sheath or both,
suitable for use as a protective conductor, or be of insulated concentric construction. Buried cables
shall be marked by cable covers or a suitable marking tape. Buried conduits and ducts shall be
suitably identified. Buried cables, conduits and ducts shall be at a sufficient depth to avoid being
damaged by any reasonably foreseeable disturbance of the ground.
•
An electrician must be consulted if in any doubt about your own competency.
If the Class II, Double Insulated symbol
is on the Light Fitting then the Fitting does not require an Earth
and Live or Neutral must not be connected to Earth.
If any modification is made it will invalidate the warranty and may render the product unsafe.
If there is a “Minimum Distance” Label, please do not allow Flammable Materials to rest within that distance
from the lamps.
If the Light Fitting must not be mounted on combustible surfaces there will be the above symbol on it.
If there is no symbol then the Light Fitting may be mounted on any surface, including combustible ones.
IP 44 Rated Outdoor Post Lanterns
Safety Warnings
This pack contains:
1x Light Fitting
Required number of Screws
Required number of wall plugs
1x 3 or 2 -way Terminal Block (may be fixed)
Appropriate bulbs if supplied
Shades according to design (supplied)
Tools required:
Drill & assorted drill bits; masonry &/ or wood
Safety glasses
Small electrical screw driver
Medium cross head screwdriver
Medium flat head screwdriver
Small Pliers with wire stripper
Electrical Insulation Tape.
Minimum Distance: This is
the symbol which denotes
this requirement.
Luminaires not suitable for direct mounting
On normally flammable surfaces (surface
Mounted)
DISTANCE
