Endace DAG 4.3GE, Руководство пользователя

Страница: 10 / 43

Endace Measurement Systems Ltd EDM01.05-01r1 DAG 4.3GE Card User Manual
www.endace.com
2.0 INSTALLING DAG 4.3GE CARD
Introduction The DAG 4.3GE card can be installed in any free PCI-X 1.0 slot. It will
operate at 66, 100, or 133MHz PCI-X mode, however it will not operate
correctly in 32 or 64-bit PCI slots.
Higher speed slots are recommended for best performance.
The DAG 4.3GE should be the only device on the PCI-X bus if possible
as the cards make very heavy use of PCI-X bus data transfer resources.
Although the driver supports up to four DAG cards by default in one
system, due to bandwidth limitations there should not be more than one
card on a single PCI-X bus.
In this section This section covers the following topics of information.
•
Installation of Operating System and Endace Software
•
Insert DAG 4.3GE Card into PC
•
DAG 4.3GE Card Port Connectors
•
Pluggable Optical Transceivers
2.1 Installation of Operating System and Endace Software
Description If the DAG device driver is not installed, before proceeding with the next
chapter, install the software by following the instructions in EDM04-01
Linux/FreeBSD Installation Guide.
To install the software on a Windows operating system, follow the
instructions in EDM04-02 Windows Installation Guide.
Go to the next chapter of information when the DAG device driver is
installed.
2.2 Insert DAG 4.3GE Card into PC
Description
Inserting the DAG 4.3GE card into a PC involves accessing the PCI-X bus
slot, fitting the card, and secure the bus slot screw.
Procedure Follow these steps to insert the DAG 4.3GE card.
Step 1. Access bus Slot
Power computer down.
Remove PCI-X bus slot cover.
Continued on next page
Copyright© All rights reserved
5
Revision 6. 22 September 2005.