IBR-10™ Installation Guide
13
Note:
If the device’s software detects an error in the configuration, it will not save it. Review the
configuration. After you have revised the configuration to your satisfaction, save it.
3
Press
Enter
.
F Restarting (Resetting) the Device
To use the saved configuration, you must reset the IBR-10. Do the following:
Note:
If you want to use your new configuration, you must save (write) the configuration before
resetting the unit. Otherwise, the new configuration will be lost.
1
On the Main Menu, select
Reset Unit
.
2
Select
Yes.
Note:
If you have not yet saved the new configuration, the system asks whether to save it.
Answer
yes
or
no
.
❖
The device resets.
3
Regardless of screen instructions, do not type anything until you see the banner:
BANDIT,
ENCORE NETWORKS INC
. Then press
Enter
.
❖
The Main Menu is displayed.
G Exiting a Session
After the software has been configured, save (write) the configuration. Then exit the session before
disconnecting the PC, so that communication is not disrupted.
Caution:
Before you exit, make sure you save (write) the configuration. Otherwise, the changes
you configured will be lost. See
Section E,
Saving (Writing) the Device’s Configuration
.
To exit the session, do the following:
1
On the Main Menu, select
Exit Session
.
2
Select
Yes
.
Note:
If the configuration has not been saved, the device asks you whether it should save the
new configuration. Answer
Yes
(or
No
, if you prefer not to save the configuration).
❖
The system notifies you that it is ending the session.
3
To reconnect to the device, press
Enter
.
❖
The Main Menu is displayed.
!
Содержание IBR-10
Страница 14: ...14 IBR 10 Installation Guide...