V er0 5.
0 5.
03
Enclume
Classic Décor Oval Rack
DR1 KD
Enclume Décor racks are the ultimate in
quality, design, strength and function.
Congratulations for owning one of the finest
storage racks made.
WARNING:
READ ALL OF THE INSTRUCTIONS
BEFORE ASSEMBLING AND USING YOUR RACK.
Enclosed you will find everything needed for the assembly and use of your pot rack. Two people make assembly and
installation easier. The parts and hardware included are
Components included:
1 - Hammered Steel Oval
1 - Cross Bar
4 - Curved Brackets
1 - Grid
Hardware included:
2 - Ceiling Screw Hooks
2 - Chain approx. 6"
2 - 'S' Hooks 2"
12 - Pot Hooks
4 - Grid Brackets - EGB
1 - 1/8" Hex Key
2 - #10 x 3/8" Button Head Screws
2 - #10 x 5/8" Button Head Screws
Toggle Kit
ASSEMBLY AND INSTALLATION INSTRUCTIONS
1)
Lay rack body (oval) on firm surface. Protect surface with corrugated box if necessary.
2)
Using two #10 x 3/8" button head screws, attach cross bar to both ends of the oval. (The cross bar will fit to the outside of
the rack body). Do not fully tighten screws at this time.
3)
The curved brackets are pre-assembled as a set, each set will have one curved bracket with a "tapped" (threaded hole)
and one with a drilled (no threads). Remove the #10 x 5/8" button head from one set. Slipping each curved bracket (end
with the tight "U" shape bend) onto the rack body one on each side of the rack, using the #10 x 5/8 button head screw,
attach the two curved brackets and the cross bar together. (Please use the hole closest to the end of the cross bar, the
larger of the two holes must be used to hang fixture).
4)
Repeat process for other set of curved brackets. Securely tighten all screws at this time.
5)
Your rack can be carefully anchored into solid wood of the ceiling joist or beams. Carefully measure the area where the
rack is to be hung and install the ceiling screw hooks (approximately 14" apart). If you are mounting in plasterboard, use
the Toggle provided and follow the directions in the Toggle kit.
6)
Place the four grid brackets over the sides of the rack on the inside of each of the four curved brackets with the straight
end of the brackets facing towards the inside of the rack. Next place the grid on top of the grid brackets. (See note next
page).